Kostenloser Rohrreibungsverlust-Rechner

How Pipe Friction Loss Works

When water flows through a pipe, it loses pressure due to friction against the pipe walls. The longer the pipe, the narrower the diameter, and the faster the flow, the more pressure you lose. This matters for plumbing design, irrigation systems, fire suppression, and any application where you need a certain pressure at the end of a pipe run.

The Formula (Darcy-Weisbach)

hf = f x (L/D) x (v^2 / 2g)

hf = Head loss (pressure drop in feet or meters of fluid)

f = Friction factor (depends on pipe material and flow speed)

L = Pipe length

D = Inside diameter of the pipe

v = Flow velocity

g = Gravitational acceleration (32.2 ft/s² or 9.81 m/s²)

The friction factor (f) depends on whether the flow is laminar or turbulent. For most plumbing and construction applications, flow is turbulent, and the friction factor is determined by the pipe material roughness and the Reynolds number.

When to Use This

Sizing pumps for a building, designing irrigation pipe runs, checking whether your existing plumbing can handle a higher flow rate, or figuring out why water pressure drops at the far end of a long pipe run. Plumbers and engineers use this calculation regularly.

What Changes the Result Most

Pipe diameter has the largest effect. Doubling the diameter reduces friction loss by roughly a factor of 32 (it scales with the fifth power of diameter). This is why undersized pipes create such dramatic pressure problems. Pipe material matters too. Smooth PVC has much less friction than corroded galvanized steel.

Common Mistakes

Using the outside diameter instead of the inside diameter. A 1-inch copper pipe has an inside diameter of about 0.995 inches, but a 1-inch steel pipe has an inside diameter of about 1.049 inches. The nominal size isn't the actual flow diameter.

Forgetting to account for fittings (elbows, tees, valves). Each fitting adds equivalent pipe length. A standard 90° elbow adds roughly 30 pipe diameters of equivalent length.

Assuming friction loss is linear with flow rate. It's not. Doubling the flow rate roughly quadruples the friction loss.