Calculateur de Taille de Pile
Calculez la taille de pile nécessaire pour votre application embarquée.
Typically 0.4 V for standard I2C
3 mA for standard, 20 mA for fast-mode+
1000 ns standard, 300 ns fast, 120 ns fast+
Minimum Resistance
967 Ω
Minimum Resistance vs Required Rise Time
Formule
## I2C Pull-Up Resistor Sizing I2C uses open-drain outputs with pull-up resistors. Too small a resistor exceeds sink current; too large slows the rise time. ### Formulas **R_min = (VCC - V_OL) / I_OL** (current limit) **R_max = t_rise / (0.8473 x C_bus)** (rise time limit) The 0.8473 factor comes from the RC time constant to reach 0.7 x VCC. Choose a standard value between R_min and R_max. Closer to R_min for faster speeds, closer to R_max for lower power.
Exemple Résolu
3.3 V supply, standard I2C (3 mA sink, 300 ns rise time), 200 pF bus.
- 01R_min: (3.3 - 0.4) / 0.003 = 967 ohms
- 02R_max: 300e-9 / (0.8473 x 200e-12) = 1770 ohms
- 03Recommended: (967 + 1770) / 2 = 1369 ohms
- 04Use nearest standard value: 1.2k or 1.5k ohms
Questions Fréquentes
Can I use the same pull-ups for SDA and SCL?
Yes, both lines typically use the same pull-up value since they have similar capacitance and timing requirements.
What if the bus has too much capacitance?
Reduce capacitance by shortening traces, reduce the number of devices, or use an I2C bus buffer/repeater.
Do I need pull-ups on every I2C device?
No. Only one set of pull-ups per bus. Multiple pull-ups in parallel reduce the effective resistance, potentially too low.
Apprendre